« previous next »
Pages: [1]

Author Topic: mikuni question  (Read 1431 times)

day-clen

  • Posts: 2015
    • View Profile
mikuni question
« on: October 19, 2013, 10:06:59 pm »
anyone ever had a problem with a vm20 w/ the o ring that seals between the spot in the float bowl that goes to the main jet to the emulsion tube?  If this isnt sealing it would allow fuel through and cause rich running condition reguardless of the jet size correct?
Sorry for the shitty description and no pictures, hopefully thats enough info to work with.
Logged
citta-apparently pronounced "cheetah"

day-clen

  • Posts: 2015
    • View Profile
Re: mikuni question
« Reply #1 on: October 19, 2013, 10:12:23 pm »
I think what I referred to as the emullsion tube is the needle jet actually
Logged
citta-apparently pronounced "cheetah"

day-clen

  • Posts: 2015
    • View Profile
Re: mikuni question
« Reply #2 on: October 21, 2013, 09:44:13 am »
so it does is the answer.  now where to get a proper side o ring, I have a huge set, nothing there quite right.  emailed some mikuni vendors, anyone found a particularly helpful vendor?
Logged
citta-apparently pronounced "cheetah"
Pages: [1]
« previous next »