Author Topic: where to find Jets!?  (Read 2012 times)

that_fawqin_guy

  • Guest
where to find Jets!?
« on: August 06, 2008, 03:38:46 pm »
blank
« Last Edit: July 10, 2009, 12:55:53 pm by blank »

Tom!

  • Administrator
  • I.R.E.
  • *
  • Posts: 6111
    • View Profile
    • Expose for the Shadows
Re: where to find Jets!?
« Reply #1 on: August 06, 2008, 05:42:18 pm »
mopedjunkyard.com
TreatsHQ on eBay
1977mopeds.com

Or Aldis
Creativity will always overcome lack of material.
These are challenges I put myself through to keep from sitting still.
Its about doing it the right way once instead of a convoluted way every time you want to make a change.

that_fawqin_guy

  • Guest
Re: where to find Jets!?
« Reply #2 on: August 07, 2008, 02:58:02 pm »
blank
« Last Edit: July 10, 2009, 12:56:09 pm by blank »

Mike Pee

  • Administrator
  • I.R.E.
  • *
  • Posts: 7539
    • View Profile
Re: where to find Jets!?
« Reply #3 on: August 07, 2008, 02:59:49 pm »
Is the 70cc kit for your express?  And is the jet for the Kei Hin carb that came on the Honda?  I didn't think Treats sold them...good to know.

You should bring this whole project down to Fort Hinrichs on Sunday.

Tom!

  • Administrator
  • I.R.E.
  • *
  • Posts: 6111
    • View Profile
    • Expose for the Shadows
Re: where to find Jets!?
« Reply #4 on: August 07, 2008, 03:00:23 pm »
Wild Oats no longer exists, and Whole Foods doesn't carry Organic Jets, I don't reccomend them, they are grown by underpaid workers, and are processed in terrible chemicals.
Creativity will always overcome lack of material.
These are challenges I put myself through to keep from sitting still.
Its about doing it the right way once instead of a convoluted way every time you want to make a change.

that_fawqin_guy

  • Guest
Re: where to find Jets!?
« Reply #5 on: August 07, 2008, 03:14:45 pm »
blank
« Last Edit: July 10, 2009, 12:56:21 pm by blank »

ire mark

  • Sergeant
  • I.R.E.
  • *
  • Posts: 3726
    • View Profile
Re: where to find Jets!?
« Reply #6 on: August 07, 2008, 04:12:23 pm »
just buy a set of drill bits, you can dribble solder in a big jet, and drilll up till you got it right, don't even have to take the carb off, just tilt it....if you've gone too big, just solder it again....very simple ,,,,,minded. and you can read the bit index without finding you glasses......
Gal?tophile Chronique